Template File for Probing Solution at User-Defined Locations (proj_name.probes)
#WARNING: DO NOT DELETE ANY LINE STARTING WITH # sign.
#THIS IS AN EXAMPLE PROJECT.PROBE FILE THAT SHOULD BE USED WITH
#MIXED-ELEMENT USM3D.
#1ST LINE: #of_probe_groups, iter_to_begin_probeout,
# frequency_of_probeout, #of_output_functions
#2ND LINE: integer list of output_functions(1:#of_output_functions)
# -1 for X; -2 for Y; -3 for Z; 1 for RHO; 2 for U; 3 for V;
# 4 for W; 5 for P; 6 for TEQ1; 7 for MUT; 50 for DP/Pinf
#3RD LINE: Name of the probe group
#4TH LINE: #of_probes_in_a_probegroup
#5TH LINE ONWARD: x, y, z of each probe point in the group
#REPEAT LINES #3, #4 #5,... FOR THE REMAINING PROBE GROUPS
#IF EITHER iter_to_begin_probeout or frequency_of_probeout
#IS LESS THAN ZERO THAN PROBE OUTPUT WILL ONLY BE WRITTEN
#AT THE END OF A RUN.
#CAUTION: CARE MUST BE TAKEN TO SPECIFY PROBES COMPLETELY
#WITHIN COMPUTATIONAL DOMAIN.
#IN THE EXAMPLE BELOW (SEE LINES STARTING WITH #SIGN) THERE
#ARE TWO PROBE GROUPS. USER DESIRES TO WRITE PROBE OUTPUT FROM
#5000TH ITERATION WITH A FREQUENCY OF 1000 ITERATINS. HERE
#"ITERATINS" MEANS ITERATINS FOR #STEDAY-STATE RUN AND TIME
#STEPS FOR TIME-ACCURATE RUN. USER DESIRES TO OUTPUT THREE
#QUANTITIES. THE LIST OF QUNATITIES SPECIFIED IN THE NEXT
#LINE INCLUDES X-COORDINATE OF PROBE, U-VELOCITY AND PRESSURE.
#FIRST PROBE GROUP, NAMED AS, "PG_A", HAS THREE AND SECOND
#PROBE GROUP, NAMED AS "PG_B", HAS FOUR PROBES. X, Y, AND Z
#COORDINATES OF EACH PROBE ARE LISTED IN SEPARATE LINES
#AFTER LISTING #NUMBER OF PROBES IN EACH GROUP.
#2,5000,1000,3
#-1,2,5
#PG_A
#3
#1.0, 0.0, 3.0
#2.0, 0.0, 3.0
#3.0, 0.0, 3.0
#PG_B
#4
#5.0, 25.0 1.0
#5.0, 25.0 2.0
#5.0, 25.0 3.0
#5.0, 25.0 4.0
1,-1,-1,2
-1,6
VERTICAL_RAKE
5
1.0 1.0 1.0
2.0 1.0 1.0
3.0 1.0 1.0
4.0 1.0 1.0
5.0 1.0 1.0